Menu
Menu
Here you will find an overview of all components in the Avara alarm system. Components can be ordered as additions or replacements for components supplied in the alarm packages. It is important to remember that you always start with a complete package, and possibly expand from it.
Contact us at Avara if you have any questions about expansions and the use of individual components!
Used to operate the alarm/night alarm inside the motorhome/caravan. Contains a motion detector, CO detector and smoke detector as well as a moisture and temperature sensor. The combination of CO detector and smoke detector increases safety for early detection of fire. The CO detector and smoke detector are always on ("Always-on") and are not turned off when the alarm is deactivated. The main unit is placed above the living area door in your motorhome/caravan.
Features
Control panel for operating a burglar alarm and night alarm
Optical smoke detector
Motion Detector
CO detector (carbon monoxide)
NFC code chip reader
Motion Detector
Passive infrared
Dimensions H, W, D
31x72x102mm
NFC
13.54Mhz
Power consumption
approx. 0.1 mA.
Power supply
3 internal replaceable AA alkaline batteries
Radio communication
868 MHz band
Motion sensor that is placed in doorways, cargo areas and hatches and detects any movement in/out of the motorhome/caravan. 3 intrusion detectors are included in the basic package, and more can be ordered if required. The detectors have an internal battery with a long life expectancy.
Dimensions H, W, D
89x70x24 mm
Motion Detector
Passive infrared
Power consumption
< 0,1 mA.
Power supply
3 internal replaceable AA alkaline batteries
Radio communication
868 MHz band
Exterior detectors alert you to unwanted guests outside in Night Alarm mode. The detectors are mounted high up on the exterior wall on each side of the motorhome/caravan so that they cover all doors.
The detectors contain a motion detector that detects movement within approx. 1 - 1.5 meters from the wall and approx. 3 meters to each side. LED light turns on in the event of movement. Two exterior detectors are included in the basic package, and more can be ordered if required, for example for long cars/vehicles.
The detector can also be used to monitor bicycle racks (night alarm). The detectors have an internal battery with a long life expectancy.
Dimensions H, W, D
50 x 218 x 45 mm
Motion Detector
Passive infrared
Power consumption normal
< 0,1 mA
Power consumption with light
350 mA
Power supply
6 pcs AA alkaline batteries
Density
IP66
Radio communication
868 MHz band
The propane gas detector should be connected to a constant 12V power supply and mounted down by the floor (5-15 cm above the floor). The detector does not turn off when the alarm is deactivated, but is always on for added security. The device has a power-saving mode that ensures that the battery is not drained when the motorhome/caravan is not in use. You can also connect a backup battery if you remove the main battery during storage.
Dimensions H, W, D
17.5 x 45 x 45 mm
Power consumption normal mode
approx. 20 mA
Power consumption in burglar alarm and save mode
approx. 0.25 mA
Power supply primary
External 5.5 – 15 V DC
Power supply backup
External 5.5 – 15 V DC
Sensitivity
Approx. 0.4% / 20% LEL
Radio communication
868 MHz band
The modem communicates with Avara's cloud solution. Alarm messages and notifications are sent to wherever the owner of the system chooses. The modem also contains a GPS unit for tracking/locating the motorhome/caravan.
The device has a power saving mode that ensures that the battery does not discharge when the motorhome/caravan is not in use. You can also connect your own battery backup in case you remove the main battery during storage.
Dimensions H, W, D
17x83x83mm
Connection
2G/4G/5G/NB-IOT/CAT-M1
Positioning
GPS/Galileo/Glonass/Beidou
NFC
13.54Mhz
Power consumption save mode
approx. 0.25 mA.
Power consumption 4G active
approx. 12 mA.
Power consumption 2G active
approx. 350 mA.
Power supply, primary
5.5-15V DC
Power supply, backup
5.5-15V DC
Radio communication
868 MHz band
The humidity sensors measure relative humidity (RH%) and temperature once a day inside the structure where they are installed. They send this data to My Page at www.avara.no, which you can access when you subscribe.
12 sensors are included in the basic package, and more can be ordered if required. The location is determined by your dealer, who has experience of where your motorhome/caravan is most exposed to moisture and where water/moisture collects. Moisture sensors are installed by a trained dealer. The starting point for installing the sensors is the places where a manual moisture measurement is normally carried out.
The sensors have an internal battery with a life expectancy of over 15 years.
Goal
Sensor Housing: Diameter: 33.5mm, Height: 9.5mm
Sensor probe: Diameter: 6 mm, Length: 20 mm
Density
IP66
Power consumption
< 0,001 mA
Power supply
CR2032 Lithium battery
Radio communication
868 MHz band
The key fobs included in Avara Lite, Avara Basic, Avara Basic Plus and Avara Premium are used to activate and deactivate the burglar alarm.
Dimensions H, W, D
40x32x4mm
Frequency
13.54 MHz
The siren driver is the control unit and power source for the external siren that is triggered in the event of a break-in. It contains AA batteries and should therefore never be connected to an external power source.
The siren driver is installed concealed together with the siren, preferably indoors - alternatively in the engine compartment of motorhomes.
Dimensions H, W, D
80 x 80 x 48 mm
Power consumption in standby
< 0,1 mA
Power consumption at active siren
approximately 250 mA, limited to approximately 500 mA
Power supply
8 pcs replaceable AA alkaline batteries
Density
IP66
Radio communication
868 MHz band
The siren is connected directly to the siren driver and placed together with it. The siren gives a loud audible warning when the intruder alarm is triggered (it is not used in Night alarm mode).
Dimensions H, W, D
53 x 50 x 63 mm
Voltage
6 – 16 V
Power consumption max at active siren
290 mA
Volume
123 dB of 10 cm. distance
Frequency
2 – 4 KHz
Avara's universal gas detector reacts to a number of different gases, including what is often called "narcotic gas".
We have made it "smart" so that it is only active when the Smart Night alarm is activated. This reduces false alarms from normal fumes/gases that may be present in a motorhome/caravan. The detector is connected to a constant 12V power source and placed high on the wall inside the motorhome/caravan. The alarm is notified to the Avara main unit.
Dimensions H, W, D
45 x 45 x 17.5 mm
Power consumption active
approx. 25 mA
Power consumption of
< 0,1 mA
Power supply primary
External 5.5 – 15 V DC
Power supply secondary
External 5.5 – 15 V DC
Radio communication
868 MHz band
For those of you who want to have black covers on the intrusion detectors and on the main unit, we have finally made this possible. You can easily replace the cover on the intrusion detector yourself, and you can do the same for the main unit if you're a bit "technical".
Raveien 438
3239 Sandefjord, Norway
post@avara.no
+47 70 31 00 86